All products with this icon are equipped with a MIDI Interface and benefit from the optionally available FCB1010.
No matter what you play, or even if you’re an engineer with a MIDI arsenal, you’ll appreciate the way our FCB1010 helps you get the most out of your gear without tying up your hands or slowing down your performance. On top of its impressive MIDI functions, it gives you two jacks for analog switching and rugged, road-proof construction.
Software
| Software Type | Description |
|---|
| Firmware |
Please note that this update is intended for use with the FCB1010 only and will not function with any other models. To update your FCB1010 you will need to replace the original EPROM in the FCB1010 with a new EPROM which has been pre-programmed with the downloaded datafile. If you do not have the means to write this datafile to a blank EPROM, then you can order a pre-programmed EPROM from your nearest BEHRINGER authorised service centre. If you have further questions or require more detailed information we ask you to contact BEHRINGER customer support. WARNING
You must remove the cover of your BEHRINGER unit to add/exchange the EPROM. Electrical current from power cables can be hazardous. DO NOT REMOVE THE COVER OF YOUR BEHRINGER UNIT UNLESS YOU ARE QUALIFIED TO DO SO. To avoid personal injury or equipment damage, disconnect the attached power cords before you open the unit cover. Do not operate the BEHRINGER unit without the cover in place. Failure to take these precautions may result in personal injury and system damage. CAUTION
Do not make mechanical or electrical modifications to the equipment. BEHRINGER is not responsible for regulatory compliance of a modified BEHRINGER product. If you are not confident of your own ability to perform this action, then please contact one of our authorised service centres or the dealership from where the unit was purchased.
FCB1010_Firmware_V2_50_1E.zip
|
